P.S.: If you do not wish to remove the case yourself, it is advisable you seek professional assistance. You can close the lid to place the MacBook Air in sleep mode (while plugged in), and carefully plug in the battery connector while it's powered on. Once the battery connector is removed, put the MacBook Air in upright position, plug in the charger and turn on the power. Grab the clear plastic pull tab attached to the battery connector and pull it toward the front edge of the Air to disconnect the battery from the logic board.Now remove the battery connector as instructed in the article, MacBook Air 13" Early 2015 Battery Replacement. Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.Your Mac will boot into the recovery partition.
Shut down your Mac, turn it on while holding down Command+R.
You'll need a special screwdriver that can remove 5-point Pentalobe screws. Step One: Boot From Recovery Mode, or an Installer Your Mac’s Recovery Mode is a treasure trove of useful tools, and it’s the easiest way to wipe your computer and start from scratch. Remove the 10 screws using the below mentioned screwdrivers.:ĩ mm P5 Pentalobe screws (2 nos.) (Shown in Red).Ģ.6 mm P5 Pentalobe screws (8 nos.) (Shown in Orange). You can follow the instructions shared on the iFixit website, MacBook Air 13" Early 2015 Lower Case Replacement, to remove the bottom case: You'll need to open the bottom case of your MacBook Air and remove the battery connector.
0 kommentar(er)
